Adjusting The Conveyor Board - JUKI FX-1 Maintenance Manual

FX-1/FX-1R Maintenance Manual
The cable assemblies shown in the table below are to be added in automatic PWB width adjustment
motor option.
Connect them according to the instructions shown in the table.
Part No. Part name
L900E321000 2-phase stepping motor with encoder
L810E8210A0 AWCS ENC CABLE ASM
L810E3210A0 AWCS-MTR CABLE ASM
L813E1210A0 AWCS NEAR SENSOR ASM
L813E0210A0 AWCS NEAR SENSOR CABLE ASM
The cable assemblies shown in the table below are to be added in Non stop operation option.
Connect them according to the instructions shown in the table.
Part No. Part name
L823E9210A0 NON STOP SIGNAL RELAY CABLE (F) ASM Relay connector MPTL_F_
L824E0210A0 NON STOP SIGNAL RELAY CABLE (R) ASM Relay connector MPTL_F_

13-7-2. Adjusting the CONVEYOR Board

This CONVEYOR board mainly relays the IN/OUT MOTOR control, transport sensor, and solenoid
valve open/close operations.
The jumper switches and DIP switches on the CONVEYOR board assembly used in the transport
unit have already been set at delivery. However, check that they are set as shown below before
setting the CARRY board assembly in the transport unit.
SW5 W3 SW4
The following describes how to set up each jumper switch and DIP-switch. For machines other
than those having the special specifications, always use the above settings.
W1 IN MOTOR Brake time setting
1-2 Basic clock x 7
3-4 Basic clock x 6
5-6 Basic clock x 5
7-8 Basic clock x 4
9-10 Basic clock x 3
W2 OUT MOTOR Brake time setting
1-2 Basic clock x 7
3-4 Basic clock x 6
5-6 Basic clock x 5
7-8 Basic clock x 4
9-10 Basic clock x 3
W4 SW3 W5 SW2
* Setting is not needed.
Pattern is short-circuited.
* Setting is not needed.
Pattern is short-circuited.
Star point
−
Relay connector CN130
AWCS MOTOR
−
Relay connector CN150
Start point
W6 SW1
The shaded areas in the figure indicate:
(1) for DIP switches, the direction to which
is to be set, or
(2) for headers, the portion to which a
jumper is to be installed.
13-28
End point
Relay connector CN130
POS CNN PCB CN35
AWCS DRV CN2
Relay connector CN150
POS CNN PCB CN25
End point
CONVEYOR PCB CN16
CONVEYOR PCB CN17
W7
Rev. 2.00