Replacing The Stbl Encoder - JUKI FX-1 Maintenance Manual

FX-1/FX-1R Maintenance Manual

5-18. Replacing the STBL Encoder

(1) Detach the support table in the same manner as described in section 5-17, Replacing the STBL
motor.
(2) Loosen the fixing screws
timing belt. Take out the encoder unit assembly.
(3) Loosen the screw attached to the encoder (set screw
encoder.
Reassemble the components in the order of steps (3) to (1).
Adjust the flatness of the support table as described in 5-17 "Replacing the STBL Motor."
After the components have been reassembled, obtain the support table offset from MS parameters.
and move the encoder unit assembly
Figure 5-18-1
) and fixing screws
5-22
to loosen the tension of the
to detach the
Figure 5-18-2
Rev. 2.00