JUKI FX-1 Maintenance Manual page 150

FX-1/FX-1R Maintenance Manual
(3) The FlexlineDB installer is started up. "The Choose Destination Location" screen will appear.
The installation destination folder can be changed by selecting the [Browse...] button. Normally,
do no change the installation destination and select the [Next] button with the destination
currently displayed on the screen.
(4) When the 1st FD has been installed completely, the following message (Setup Needs the
Next Disk) will appear. Insert the 2nd FD into the FDD and click the [OK] button.
(5) When each FD has been installed, the same message will appear. Follow the instructions to
insert the specified FD and select the [Next] button to complete the setup.
(6) Select the [Start] button and restart WindowsNT.
WindowsNT starts running and the FX-1 system is then started up.
CAUTION
Before starting the origin return of the equipment, always
restore the backup data. (For details, see the following pages.)
Failure to do so may cause the equipment to run as you do not
expect.
12-34
Rev. 2.00