FX-1/FX-1R Maintenance Manual
5-21-2. Adjusting the Z-phase of the YA-ball screw
NEAR
SENSOR
LIMIT
SENSOR
(1) In the status that
the
YA-motor
and coupling are
fixed
and
the
YA-ball
screw
and coupling are
free, move the
table
to
position
where
the near sensor
is turned ON.
(2) Put a mark at
the
position
where the near
sensor is turned
ON.
(3) Escape the table
to
a
position
where
the
coupling can be
seen.
(4) Detect the
Z-phase when
rotating the c
oupling
and put the
mark. (See Figures 5-21-2-2 and 5-21-2-3.)
(5) Make the Z-phase mark matched with the sensor ON angle mark, move the table toward the
servomotor by 1/4 rotation, and then fix the coupling firmly.
a
Sensor
dog
YA-ball
screw
Free →
Put a mark at
Fixed
the top.
Fix
YA-motor
Figure 5-21-2-1
5-26
Turn 1/4
rotation
Rev. 2.00