UG-1828
Default Timing Parameters for Transmitter Channels
Figure 66 shows the ADRV9001 transmitter required timing parameters and their minimum, maximum, and default values as well as
some recommendations are summarized in Table 24.
PIN: TX_ENABLE
TX_INTERFACE
TX ANALOG POWER
TX ON: ANTENNA POWER
Table 24. ADRV9001 User Provided Transmit Timing Parameters
Timing Parameter
enableRiseToAnalogOnDelay
(t
)
TxEnaRise2AnaOn
enableRiseToOnDelay
(t
)
TxEnaRise2On
enableGuardDelay
(t
)
TxGT
(Not Used Currently)
enableHoldDelay
(t
)
TxEnaHold
(Not Used Currently)
enableFallToOffDelay
(t
)
TxEnaFall2Off
Default Timing Parameters for Receiver Channels
Figure 67 shows the ADRV9001 receiver required timing parameters and their minimum, maximum, and default values as well as some
recommendations are summarized in Table 25.
PIN: RX_ENABLE
RX ON: LNA POWER OUT
RX ANALOG POWER
RX_INTERFACE
t
RxGT
t
RxEnaRise2On
t
RxEnaRise2On
Figure 66. Transmit Timing Parameters
Min Value
Max of the following values: 0
propagationDelay –
enableSetupDelay
t
(for the maximum
PowerUpPSM
intended power savings mode)
enableRiseToAnalogOnDelay +
enableSetupDelay
0
0
enableHoldDelay
t
RxEnaRise2On
t
RxEnaRise2On
t
RxGT
Figure 67. Receiver Timing Parameters
Rev. PrA | Page 72 of 253
VALID DATA
Max Value
91 ms/scaleFactor
91 ms/scaleFactor
91 ms/scaleFactor
91 ms/scaleFactor
enableHoldDelay +
propagationDelay
t
t
Preliminary Technical Data
t
RxEnaHold
t
RxEnaFall2Off
t
RxEnaFall2Off
Comment
Default = min
Default = min
Not needed if not controlling LNA power
Default = min
Can increase to non-zero if performance
degradation is observed and the channel
is transmitting for some time before the
start of the actual frame
(Forced to be 0 currently by ADRV9001)
Default = min
Can increase if performance degradation is
observed and the channel is transmitting
for some time after the end of the actual
frame
(Forced to be 0 currently by ADRV9001)
Default = max
Can decrease if not all data sent through
interface needs to be transmitted.
RxEnaFall2Off
RxEnaFall2Off
t
RxEnaHold
Need help?
Do you have a question about the ADRV9001 and is the answer not in the manual?