Removing the Level Sensor, Melt RTD, or Melt Thermostat
1
Figure 6-4
Melter panels
1. Front panel
E 2020 Nordson Corporation
Remove Melter Panels
1. De-energize the melter. Refer to Safety (Section 1).
2. Disconnect the melter air supply and remove the air filter.
3. Remove the front panel of the melter by loosening the four latches. See
Figure 6-4.
NOTE: For MOD systems, remove the right and rear panels.
4. Remove the pump cover by unfastening the two screws.
2
3
2. Rear panel
Troubleshooting
6-21
3. Right panel
Part 1128350_02