Removing The Melter From The Sub-Base - Nordson ProBlue Flex Product Manual

Removing the Melter from the Sub-base

E 2020 Nordson Corporation
Refer to the Melter Clearances given earlier under Installation Requirements
for the recommended clearances required between the melter and
surrounding objects.
Refer to Melter Mounting Considerations given earlier under Installation
Requirements before mounting the melter.
1. See Figure 3-6. Remove the melter from the sub-base plate by loosening
the two M8 socket head cap screws on the front of the chassis using an
M6 hex wrench.
Figure 3-6 Removing melter from the sub-base
Installation 3-11
Part 1128350_02