Table of Contents
Advertisement
Installation
3-1
Section 3
Installation
WARNING! Allow only qualified personnel to perform the following tasks.
Follow the safety instructions in this document and all other related
documentation.
Overview
ProBlue Flex adhesive melters are factory-configured for each order, and are
required to be mounted, installed, and connected for operation. If your melter
was ordered as a complete system, the shipping container will also contain
one or more hot melt hoses and applicators.
The melter is shipped from the factory with an installation kit that contains
components that must be assembled onto the melter by the customer. Some
additional materials must also be supplied by the customer to complete the
installation.
The ProBlue Flex 400/480 volt melters include a transformer assembly that is
shipped separately from the melter. Refer to ProBlue Flex 400/480 Volt
Transformer (Appendix F) for installation instructions, parts information, and
wiring details.
If optional equipment was ordered with the melter, refer to the documentation
provided with the optional equipment for installation and operating
instructions.
Part 1128350_02
E 2020 Nordson Corporation
Advertisement
Table of Contents
Troubleshooting
