Output Parameters - Nordson ProBlue Flex Product Manual

Installation
3-38

Output Parameters

Selection
Disabled Output not used
Temperature Ready All temp zones within 5 °F set point, no faults or alerts,
system not in setback, ready delay complete
System Run-Ready System State = Run (Temp Ready, Pump On, Patterns
Enabled)
Fill Ready Fill system is enabled and no fill faults
Temperature Temp Ready and Pump On conditions met (Does not
Ready-Pump On include other subsystems such as fill, flow or pattern) - for
legacy support
Fill Active Active fill signal causes output active
Fill Overfill Alarm Max Fill time exceeded (overfill alarm) causes output
active
Fill Stop Fill system stop causes output active
Tank Low Adhesive level in tank low causes output active
System Alert Any active system alert causes output active
NOTE: System Alert and fault are inverted and the
check-box is selected. The invert check-box is
automatically selected on factory reset.
System Fault Any active system fault causes output active.
NOTE: System Alert and fault are inverted and the
check-box is selected. The invert check-box is
automatically selected on factory reset.
High Flow Alert Flow Monitor related alert causes output active when
above the alert limit
Low Flow Alert Flow Monitor related alert causes output active when
below the alert limit
High Flow Stop Flow Monitor related stop causes output active when
above the stop limit
Low Flow Stop Flow Monitor related stop causes output active when
below the stop limit
Part 1128350_02
Table 3-5 Output Parameters
Functions Hardware Option Required
N/A
N/A
N/A
Fill System
N/A
Fill System
Fill System
Fill System
Level Sensor (Basic/Legacy)
N/A
N/A
Flow Board and License
Flow Board and License
Flow Board and License
Flow Board and and License
Continued...
E 2020 Nordson Corporation