Connecting Expansion Base And Sub-Base Wiring To The Melter - Nordson ProBlue Flex Product Manual

Hose/Applicator Expansion Base
G-10

Connecting Expansion Base and Sub-base Wiring to the Melter

4
5
Figure G-7 Connecting ground wire from expansion base (some components not shown)
1. Sub-base
2. Chassis
Part 1128350_02
Figure G-8 shows the location of the connections on the boards.
1. To connect the wiring from the expansion base to the melter do the
following:
a. Connect the ground lead from the sub-base to the lug at the bottom of
the melter electrical enclosure (Figure G-7).
b. Connect the ground lead from the expansion base to the lug at the
bottom of the melter electrical enclosure (below the cards).
2. Slide the chassis cover place into place and install the chassis cover
screw.
3
3. Chassis cover plate screw
4. Chassis cover plate
2
1
6
5. Sub-base ground wire
connection
6. Chassis ground wire
connection
E 2020 Nordson Corporation