Customer-Supplied Materials; Mount The Melter - Nordson ProBlue Flex Product Manual

Installation
3-10

Customer-Supplied Materials

Mount the Melter

Part 1128350_02
The following additional materials are also required to install the melter:
Power cable (if the cable clamp provided in the installation kit is not
S
used, a rigid or flexible electrical conduit will be required.)
5
Four 8 mm ( / in.) machine bolts with locking hardware
S
16
A plant air supply with an in-line isolation valve
S
ProBlue Flex adhesive melters come factory-installed with the sub-base. At
the time of mounting, the sub-base needs to be removed from the melter and
mounted onto the parent machine or support structure. The melter is then
remounted onto the sub-base.
3
Figure 3-5 Melter with the chassis and sub-base
1. ProBlue Flex melter
2. Sub-base
Refer to Technical Data (Section 7) for the dimensions of the melter and the
sub-base. Refer to the technical data provided by the hot melt manufacturer
for information about the volumetric weight of the hot melt.
1
2
3. Chassis
E 2020 Nordson Corporation