Mounting The Transformer On The Parent Machine - Nordson ProBlue Flex Product Manual

Mounting the Transformer on the Parent Machine

E 2020 Nordson Corporation
1. See Figure F-7. Mark the bolt pattern on the parent machine or support
structure and then drill holes for four 8 mm (
(customer-supplied).
NOTE: Open the PCA tray to access the bolt hole location under it
(highlighted in grey in the following figure).
Figure F-7 Bolt hole location on the transformer base
2. Attach the transformer to the parent machine using four 8-mm (
machine screws. Make sure the screws securely fasten the transformer
to the support structure.
ProBlue Flex 400/480 Volt Transformer
5
/ in.) mounting bolts
16
F-11
5
/ in.)
16
Part 1128350_02