Instructions And Safety Messages; Installation Practices; Operating Practices - Nordson ProBlue Flex Product Manual

Safety
1-4

Instructions and Safety Messages

Installation Practices

Operating Practices

Read and follow the instructions provided in this document and other
S
referenced documents.
Familiarize yourself with the location and meaning of the safety warning
S
labels and tags affixed to the equipment. Refer to Safety Labels and Tags
at the end of this section.
If you are unsure of how to use the equipment, contact your Nordson
S
representative for assistance.
Install the equipment in accordance with the instructions provided in this
S
document and in the documentation provided with auxiliary devices.
Ensure that the equipment is rated for the environment in which it will be
S
used. This equipment has not been certified for compliance with the
ATEX directive nor as nonincendive and should not be installed in
potentially explosive environments.
Ensure that the processing characteristics of the material will not create a
S
hazardous environment. Refer to the Safety Data Sheet (SDS) for the
material.
If the required installation configuration does not match the installation
S
instructions, contact your Nordson representative for assistance.
Position the equipment for safe operation. Observe the requirements for
S
clearance between the equipment and other objects.
Install lockable power disconnects to isolate the equipment and all
S
independently powered auxiliary devices from their power sources.
Properly ground all equipment. Contact your local building code
S
enforcement agency for specific requirements.
Ensure that fuses of the correct type and rating are installed in fused
S
equipment.
Contact the authority having jurisdiction to determine the requirement for
S
installation permits or inspections.
Familiarize yourself with the location and operation of all safety devices
S
and indicators.
Confirm that the equipment, including all safety devices (guards,
S
interlocks, etc.), is in good working order and that the required
environmental conditions exist.
Use the personal protective equipment (PPE) specified for each task.
S
Refer to Equipment Safety Information or the material manufacturer's
instructions and SDS for PPE requirements.
Do not use equipment that is malfunctioning or shows signs of a potential
S
malfunction.
Issued 09- 19
E 2020 Nordson Corporation