Table of Contents
Advertisement
Mounting the 400/480V Melter on the Transformer
1
4
Figure F-13 Mounting the melter to the transformer
1. ProBlue Flex melter
E 2020 Nordson Corporation
CAUTION! Be sure that the transformer wire harnesses are not pinched
between the transformer and the melter.
1. Position the two side spacers retained from the transformer shipping
container on the installed transformer. Maintain the orientation of the
notches as shown in Figure F-13.
2. Carefully lower the melter onto the transformer.
2. Side spacers (two)
ProBlue Flex 400/480 Volt Transformer
3. Transformer
F-17
2
3
4. Routing of cables
Part 1128350_02
Advertisement
Table of Contents
Troubleshooting
