Table of Contents
Advertisement
Hose/Applicator Expansion Base
G-11
2
1
A
Figure G-8
Connecting the expansion board power cables
1. Nordnet Temperature Control Module
2. Hose/Applicator Expansion
- X6
Module - X2
CAUTION: Do not plug the Nordnet cable into the Nordnet Master #2
connector on the LVC. The system may not work properly. See Wiring
Diagram - Hose/Applicator Expansion Power Module #3 (Figure 7-23) in
Technical Data (Section 7).
3. Connect the power cable to the receptacle.
4. Close the melter's E-Box door and reinstall the side enclosure panel.
5. Connect the wires from the base into the E-Box.
Part 1128350_02
E 2020 Nordson Corporation
Advertisement
Table of Contents
Troubleshooting
