Set Up The Melter Inputs And Outputs (I/O); I/O Connections - Nordson ProBlue Flex Product Manual

Installation
3-36

Set Up the Melter Inputs and Outputs (I/O)

I/O Connections

INPUT: 10-30VDC
OUTPUT: 2A@ 30VDC or
250VAC
Figure 3-17 Low voltage controller board I/O connections
INPUT: 10-30VDC
Figure 3-18 Legacy board I/O connections
Part 1128350_02
To access the electrical boards in the E-Box enclosure, make sure that the
E-Box enclosure door is open and the enclosure side panel is removed.
Refer to step 2 in Removing the Melter from the Sub-base given earlier in this
section.
Refer to Technical Data (Section 7) given later in this manual for specific
board details.
A3 Low Voltage Control Board
A13 PRESSURE
FILL OUTPUT: 24VDC
INPUT
DETECT: ACTIVE
LOW
A4 Legacy I/O Board
A14 PRESSURE CONTROL
OUTPUT: 2A@ 30VDC or 250VAC
E 2020 Nordson Corporation