Table of Contents
Advertisement
Installation
3-6
Ventilation
Electrical Power
Part 1128350_02
See Figure 3-3. Melters are cooled by convection. Air is drawn in through
openings in the chassis of the melter and is exhausted out of the ventilation
slots at the top of the melter.
CAUTION! Do not block the air intake openings and ventilation slots.
Figure 3-3
Melter ventilation slots
Before installing the melter, ensure that the melter will not be overloaded and
that the plant's electrical service is rated to handle the power required by the
melter and the hoses and applicators that you plan to use.
Refer to Calculating Melter Power Requirements (Appendix A) for
information about how to calculate the maximum allowable hose lengths and
applicator wattage that can be used in your manufacturing application.
WARNING! Risk of electrocution! Install a lockable power disconnect switch
between the electrical service and the melter. Failure to install or properly
use the disconnect switch when servicing the melter can result in personal
injury, including death.
E 2020 Nordson Corporation
Advertisement
Table of Contents
Troubleshooting
