Melter Operation; Filling The Melter Tank - Nordson ProBlue Flex Product Manual

Basic Melter Operation
4-2

Melter Operation

Filling the Melter Tank

Part 1128350_02
This section provides information about basic melter operating tasks.
The melter can be customized with several set up options. For detailed
instructions on how to set up the menus for specific and advanced melter
operating tasks, refer to one of the following manuals:
-
ProBlue Flex Adhesive Melter Using the OLED User Interface Manual
(P/N 1128351).
-
ProBlue Flex Adhesive Melter OEM User Interface Manual
(P/N 1129255).
Before filling the tank, confirm that the hot melt material is compatible with
the melter. Refer to Intended Use in Description (Section 2) for information
about hot melt materials that should not be used in ProBlue Flex melters.
The tank is equipped with a sensor, which allows you to configure the system
to set an alert when the volume of adhesive in the tank reaches
approximately one-half of the tank's rated capacity.
IMPORTANT:
If you have the optional Fill system, the tank will start filling once the
S
tank/grid is at its set point temperature.
Refer to Optional Accessories (Appendix E) for dimensions, technical
specifications, and parts information.
If you do not have the optional Fill system, follow the instructions given in
S
the following page.
WARNING! Hot! Risk of burns. Wear heat-protective clothing, safety
goggles, and/or heat-protective gloves. Hot melt material may be released
forcefully.
E 2020 Nordson Corporation