Hose/Applicator Expansion Base
G-8
Mounting the Melter to the Expansion Base
Part 1128350_02
CAUTION! Ensure that all wires are properly routed and not pinched
between the expansion base and the melter.
WARNING! Risk of personal injury or equipment damage. Mounting the
melter requires two people.
NOTE: Have a second person route cables through the melter as another
person holds the melter above the expansion base.
1. Carefully lower the melter onto the expansion base.
2. Slide the melter forward so that the expansion base locking tabs securely
connect with the melter.
3. Secure the expansion base to the melter using the two M8 x 20
socket-head screws removed previously. Use a 6 mm hex wrench to
tighten the screws.
E 2020 Nordson Corporation