Configure The Otm Pc To Communicate With A Remote System; Site Through A Modem Router; Configure The Rm356 Modem Router Through The Manager Menu - Nortel 1000 Description, Installation And Operation Manual

Page 610 of 644

Configure the OTM PC to communicate with a remote system

site through a modem router

Configure the RM356 modem router through the
manager menu
553-3001-363 Standard 2.00
Appendix F: Configure a Netgear RM356 modem router for remote access
If the customer's version of OTM does not support the modem router
communication profile for Meridian 1/CS 1000M system types, work around
the limitation by configuring a Dial-up Networking (DUN) session under
Windows to connect to the modem router at a particular system site.
In the OTM Navigator, configure the system communication profile as
"Ethernet." Establish the Dial-up Networking session from Windows before
attempting to connect to the system from the OTM Navigator. IP Trunk 3.01
(and later) nodes on the same ELAN subnet are also accessible over the same
Dial-up Networking connection to the modem router.
Configuring the RM356 modem router by the manager menu can be
completed from a TTY or PC connected to the local RS-232 manager port on
the rear of the modem router. Alternatively, the manager menu can be
accessed by Telnet after the IP addressing and routing have been set up
initially from the local manager port.
Note: The arrow keys navigate in the RM356 manager menu. The
spacebar key toggles pre-defined configuration values for a field. The
Enter key saves data changes to ROM and exits the current menu. The
Esc key exits the current menu without saving changes. Enter the menu
selection number, when prompted, to display a sub-menu, configuration
form, or command prompts.
Follow the steps in Procedure 79 to configure the RM356 modem router
through the manager menu.
Procedure 79

Configure the RM356 modem router through the manager menu

1 Press the Enter key.
The 'Enter Password:' prompt is displayed for 10 seconds.
September 2004