Nortel 1000 Description, Installation And Operation Manual page 630

Page 630 of 644
553-3001-363 Standard 2.00
Appendix G: Upgrade an ITG Trunk 1.0 node to support ISDN signaling trunks
Procedure 83
Removing the ITG Trunk 1.0 configuration files
1 From the OTM IP Telephony Gateway - ISDN IP Trunk Main window,
select the card from the lower half of the window and right-click. A context
menu appears. Select Telnet to ITG card. OTM automatically launches
a Telnet session to the selected card.
2 Login to the ITG shell. At the ITG> prompt, enter setLeader
setLeader "xxx.xxx.xxx.xxx", "yyy.yyy.yyy.yyy", "zzz.zzz.zzz.zzz"
where:
• "xxx.xxx.xxx.xxx" is the ELAN Management IP address of Leader 0,
• "yyy.yyy.yyy.yyy" is the ELAN Management Gateway (router) IP
address. If the OTM PC will be connected locally to the LAN, and
there is no management LAN gateway, then the Gateway IP address
is "0.0.0.0".
• "zzz.zzz.zzz.zzz" is the subnet mask for the ELAN management IP
address of Leader 0.
Note 1: All ITG shell commands are case-sensitive. A space separates
the command from the first parameter. The three parameters must each
be enclosed in quotation marks, and there must be a comma and no
spaces separating the three parameters.
Note 2: The Management Gateway (router) IP address is used on
reboot to create the IP route table default network route only if
(1) there is no active leader that has this card's management MAC
address in its node properties file, and
(2) this card's node properties file is empty (size 0 Kb).
Note 3: IP addresses and subnet masks must be entered in dotted
decimal format.
Note 4: If the network administrator has provided the subnet mask in
CIDR format, convert it to dotted decimal format before entering it. For
example: 10.1.1.1/20 must be converted to IP address 10.1.1.1 with
subnet mask 255.255.240.0. To convert subnet mask from CIDR format
to dotted decimal format refer to "Subnet mask conversion from CIDR to
dotted decimal format" on
Press Enter.
3
September 2004
page 603.