Configure Media Card 32-Port And Itg-Pentium 24-Port Trunk Cards And Units For Ip Trunk Route - Nortel 1000 Description, Installation And Operation Manual

Page 300 of 644
Configure Media Card 32-port and ITG-Pentium
24-port trunk cards and units for IP Trunk Route
LD 14 – Configure Media Card 32-port and ITG-Pentium 24-port trunk cards and
units (Part 1 of 5)
Prompt
REQ
TYPE
553-3001-363 Standard 2.00
Install and configure IP Trunk 3.01 (and later) node
Use LD 14 to configure the Media Card 32-port and ITG-Pentium 24-port
trunk cards and units. Record the first CHID for each IP trunk card on the IP
Trunk 3.01 (and later) Installation Summary Sheet.
Response
NEW XX
IPTI
September 2004
Description
Add new data, where:
xx = 1 – 24 for ITG-Pentium 24-port trunk card
xx = 1 – 32 for Media Card 32-port trunk card
When using REQ = NEW XX, configure only one
IP trunk card at a time.
When using REQ = NEW XX, CHID is
incremented for each of the new units created.
It might be necessary to configure partial IP trunk
cards due to WAN traffic capacity limitations, or
Leader and DCHIP card real-time capacity for very
large nodes and networks.
Trunk Type
IPTI is the only supported trunk type for IP Trunk
3.01 (and later) trunks.
Error message SCH5787 is printed if an attempt is
made to configure non-IPTI trunks as IP Trunk
3.01 (and later) trunks.