Nortel 1000 Description, Installation And Operation Manual page 632

Page 632 of 644
553-3001-363 Standard 2.00
Appendix G: Upgrade an ITG Trunk 1.0 node to support ISDN signaling trunks
5 Locate the ITG28xx.mms software file on the OTM PC. If the path to the
ITG28xx.mms software file is known, type the path information in the
Software field. Or click the Browse button to find and select the file. Click
the Open button in the Browser so that the software path and filename
appear in the Software field in the ITG-Transmit options window.
6 Click the Start Transmit button.
Monitor progress in the Transmit control window. Confirm that the
card software is transmitted successfully to all the ITG 8-port trunk
cards. The window identifies the cards by their TNs.
If the message in the control window indicates the software transmit is
unsuccessful, do not press Cancel. Leave the Transmit Control
window open displaying the location of the software file on OTM.
If the trunk card can be reached by Telnet from OTM, but OTM shows
the card status as Not Responding, OTM ITG SNMP MIB is
incompatible with the ITG 8-port trunk card software version. In this
case, the software upgrade must be executed from the ITG shell CLI
of each ITG 8-port trunk card in the node (see step a, and Figure 156
on page 633).
a. ITG> swDownload "IP address of OTM PC", "itguser", "obtuser",
" ","ITG28xx.mms" where xx indicates the latest version of the ITG
Trunk 2.0 software for the ITG 8-port trunk card.
Note: Be sure to hit the space bar after typing in swDownload. Enter the
quotation marks and commas exactly as described in the step a and as
shown in Figure 156 on
7 Reset the card. There are three ways to do this:
a. From the IP Telephony Gateway Main window, double-click each
card to open the Card Properties. Click the Reset button if the trunk
card is showing responding. Close the Card Properties and go to the
next card in the list.
b. If the card is showing "Not responding", Telnet to the card and enter
the following command:
ITG> card Reset
c. Press the Reset button on the trunk card faceplate.
The trunk card faceplate shows T.20 in the maintenance display
window.
September 2004
page 633.