Select An Rtp Port - Nortel 1000 Description, Installation And Operation Manual

Provisioning IP Trunk 3.01 (and later) in OTM 2.1 (and later)

Select an RTP port

Figure 100
New ITG Node – Ports tab
VAD
Figure 99 on page 408
G.711. This is the default setting for OTM 2.1 (and later).
16 When G.711 is selected as the codec option and the only remote device
on the network is an ITG 2.x trunk or an IP 3.0 trunk, then the VAD setting
can be left enabled. If the IP Trunk 3.01 (and later) node will interwork with
CS 1000S and CS 1000M, disable VAD. Only devices at the remote end
of a small number of gateways can perform VAD and understand the
pertinent signaling.
17 Click the Ports tab. See Figure 100.
shows a DSP Profile with VAD enabled for the
IP Trunk Description, Installation, and Operation
Page 409 of 644