Page 340 of 644
Figure 60
ITG Dialing Plan Remote Node Properties window – Digits dialed tab
1.
2.
3.
4.
5.
553-3001-363
Standard 2.00
Install and configure IP Trunk 3.01 (and later) node
_
1
.
Dial Plan – Click the pull-down list to display ESN translation
types/ISDN call types.
2. Dial plan digits – Dial plan digits are the Called Number digits in the
ISDN Signalling Call Setup message sent by the Meridian 1/CS 1000M
system after digit absorption, insertion, and manipulation by the system
3. Number of leading digits to delete – The number of leading digits to
delete from the Called Number digits in the Call Setup message sent by
Meridian 1 before the IP trunk card sends the Call Setup message on
outgoing calls.
4. Leading digits to insert - The leading digits to insert before the ITG
Trunk card sends the Call Setup message on outgoing calls.
September 2004