Nortel 1000 Description, Installation And Operation Manual page 508

Networks communication server, ip trunk installation

Hide thumbs Also See for 1000:

Table of Contents

Page 508 of 644

553-3001-363

Standard 2.00

OA&M using the ITG shell CLI and overlays

Note 1: Disable the IP trunk card before card properties are transmitted

from the OTM IP Trunk 3.01 (and later) application to the IP trunk card.

Note 2: The card reset button is only available in the OTM IP Trunk

3.01 (and later) application when the IP trunk card is disabled.

Note 3: Disabling the IP trunk card in LD 32 does not disable the Active

Leader or Backup Leader functions.

"Disable the indicated IP trunk card when idle" on

Note: This temporarily prevents the IP Trunk 3.01 (and later) node from

seizing the port from incoming calls.

"Disable an indicated IP trunk card port" on

"Enable an indicated IP trunk card" on

"Enable an indicated IP trunk card port" on

"Display IP trunk card ID information" on

Note 1: This command displays the PEC (Product Engineering Code)

for the card. The PEC is as follows:

ITG 8-port trunk card – NT0961AA

ITG-Pentium 24-port trunk card – NT0966AA

Media Card 32-port trunk card – NT0966BA

Note 2: The IP trunk card ID information displays the same IP trunk

card serial number that is displayed from the ITG shell using

serialNumShow

"Display IP trunk card status" on

"Display IP trunk card port status" on

September 2004