Retrieve The Ip Trunk 3.01 (And Later) Node Dialing Plan Using Otm - Nortel 1000 Description, Installation And Operation Manual

Page 342 of 644
Retrieve the IP Trunk 3.01 (and later) node dialing plan
using OTM
553-3001-363 Standard 2.00
Install and configure IP Trunk 3.01 (and later) node
If adding a new node to a large existing network, it is more efficient to retrieve
the IP Trunk 3.01 (and later) node dialing plan from an existing node. Make
the necessary modifications before transmitting the dialing plan to the new
node. Follow the steps in Procedure 27 to retrieve the IP Trunk 3.01 (and
later) node dialing plan.
When OTM 2.1 (and later) is launched, it launches its own FTP service.
Other FTP services, such as those found in Windows NT4 and Windows
2000 (which are launched by default) must be turned off, or OTM 2.1
(and later) will not work properly.
Procedure 27
Retrieving the IP Trunk 3.01 (and later) node dialing plan using OTM
1 In the IP Telephony Gateway – ISDN IP Trunk window, select an
existing IP Trunk 3.01 (and later) node which has a dialing plan similar to
one to be created for the new IP Trunk 3.01 (and later) node.
2 Ensure that OTM can monitor the card state of Leader 0 in the existing
node from which the dialing plan is being retrieved. Record the
Management IP address of Leader 0 on the existing node.
3 Select the new node and double-click to open its Node Properties sheet.
4 Click the Configuration tab. Record the Management IP address of
Leader 0 on the new node.
5 On the Configuration tab, change the Management IP address of Leader
0 on the new node. Enter the Management IP address of the Leader 0
card on the existing node recorded in Step 2.
6 Click Change and then click OK.
7 Select the new node in the upper part of the IP Telephony Gateway -
ISDN IP Trunk window.
8 Select menu Configuration > Synchronize > Retrieve to open the ITG
Retrieve Options window.
September 2004
Important