Nortel 1000 Description, Installation And Operation Manual page 361

Install and configure IP Trunk 3.01 (and later) node
Procedure 37
Transmitting new software to the IP trunk cards
1 Open OTM 2.1 (and later). Click Services and launch the ITG ISDN IP
Trunks application.
2 Select the node to upgrade from the list in the upper half of the
IP Telephony Gateway - ISDN IP Trunk window.
3 Select node or cards for software transmission according to card density:
a. If all cards in the node have same card density (24-port or 32-port),
upgrade all the cards together by transmitting to the selected node.
Click the new node in the upper half of the IP Telephony Gateway -
ISDN IP Trunk window.
b. If a mix of Media Card 32-port and ITG-Pentium 24-port trunk cards
is in the same IP Trunk 3.01 (and later) node, then select all cards of
the same density in the lower half of the window. Hold down the Ctrl
key while making individual card selections.
4 Select menu Configuration/Synchronize/Transmit. The ITG - Transmit
Options dialog box appears.
5 If transmitting new software to a node, choose step a or b.
a. If transmitting new software to a node containing cards of the same
density, ensure the following:
Make sure Transmit to selected nodes is selected.
Check Card software checkbox.
Click Browse and locate the software file for the card density of
the selected node.
Click Start Transmit. The software is transmitted to each card in
turn and burned into the flash ROM on the IP trunk card. Monitor
the progress of the card software transmission in the Transmit
Control window. IP Trunk 3.01 (and later) indicates success or
failure of card software transmission by card TN. Scroll to verify
IP Trunk Description, Installation, and Operation
Page 361 of 644