Nortel 1000 Description, Installation And Operation Manual page 50

Page 50 of 644 System description
553-3001-363 Standard 2.00
For extra components, such as longer cables required for a Large System, see
Table 5 on page 51, which lists all extra components used by both IP trunk
cards. See Appendix A on
cables and connections.
Note 1: OTM 2.1 (and later) is a prerequisite and must be ordered
separately.
Note 2: Nortel Networks Netgear RM356 Modem Router or equivalent
is required for remote support and must be ordered separately from retail
outlets.
Note 3: Inspect the IPE module to determine if it is equipped with
non-removable Molded Filter Connectors on the I/O Panel. For Large
Systems manufactured during the period of 1998-1999 and shipped in
North America, the IPE modules have the NT8D81BA Backplane to I/O
Panel ribbon cable assembly with a non-removable Molded Filter
Connector. If the TLAN subnet connection is 10BaseT use the
NT8D81BA Backplane to I/O Panel ribbon cable assembly, for a
100BaseT connection use the NT8D81AA ribbon cable.
Table 4 lists the hardware components included in the IP Trunk 3.01 (and
later) packages for new installations.
September 2004
page 569 for more information on some of the