Configure Network Connections - Nortel 1000 Description, Installation And Operation Manual
Networks communication server, ip trunk installation
Hide thumbs
Also See for 1000:
- Features and services fundamentals (616 pages) ,
- Fundamentals (492 pages) ,
- Installation and commissioning manual (468 pages)
Table of Contents
Advertisement
Install and configure IP Trunk 3.01 (and later) node
Configure Network Connections
Follow the steps in Procedure 18 to configure the network connections.
Procedure 18
Configuring network connections
1
Decide subnet settings:
a.
If using separate subnets for the voice (TLAN subnet) and
management (ELAN subnet) networks, accept the default setting
Use separate subnets for voice and management check box.
b.
If using the same subnet for the voice and management network
(ELAN subnet), uncheck the Use separate subnets for voice and
management check box. The window changes.
2
If using the default setting Use separate subnets, perform steps a-d.
a.
Enter the Voice LAN Node IP address.
b.
Enter the Management LAN gateway IP address.
c.
Enter the Management LAN subnet mask.
d.
Enter the Voice LAN subnet mask fields.
The Voice LAN Node IP address on the General tab and the Voice IP and
Voice LAN gateway IP addresses for Leader 0 and Leader 1 on the Card
Configuration tab must be on the same subnet.
3
If Use separate subnets was unchecked, perform steps a-c.
a.
Enter the Management LAN Node IP.
b.
Enter the Management LAN gateway IP address. The
Management gateway (router) also functions as the voice gateway
(router).
c.
Enter the Management LAN subnet mask.
The Management LAN Node IP and Management gateway IP addresses
on the General tab and the Management IP for Leader 0, Leader 1 and
all Follower cards on the card Configuration tab must be on the same
subnet.
Note: Do not click OK or Apply until the Configuration tab has been
completed.
End of Procedure
IP Trunk
Description, Installation, and Operation
Page 319 of 644
Advertisement
Table of Contents
