Nortel 1000 Description, Installation And Operation Manual page 503

OA&M using the ITG shell CLI and overlays
Alternatively, order the latest IP Trunk 3.01 (and later) software on a PC
Card.
Upgrade IP trunk card software by PC Card
The PC Card can be obtained from Nortel Networks with the latest IP
trunk card software version. Update the IP trunk card software version on
the PC Card by copying the file from the PC hard drive to the PC Card,
which is inserted in a PC Card slot on the PC.
Follow the steps in Procedure 66 to upgrade the IP trunk card software
using a PC Card.
Procedure 66
Upgrading IP trunk card software using a PC Card
1 Insert the PC Card containing the software into the A: drive of the IP trunk
card, located on the faceplate of the IP trunk card.
2 From the ITG shell, monitor the successful insertion of the PC Card. If the
PC Card has been successfully recognized and installed, a message
indicating this is displayed.
3 Use the swDownload command to copy the software from the PC Card
to the IP trunk card flash ROM device, using the FTP client and the FTP
host on the IP trunk card. The host name parameter in this command is
the management interface IP address of the IP trunk card. The user name
and password are the same as those configured for the ITG shell. The
directory path, which is "/A:", and file name indicate the software file on
the PC Card in the A: drive.
4 Press Enter. Monitor the status of the software upgrade and check that
the upgrade correctly finishes. Observe any error messages that indicate
problems with parameters or syntax.
5 When the new software has downloaded into the flash ROM device,
reboot the IP trunk card to use it. Use the cardReset command or press
the reset button on the IP trunk card faceplate.
End of Procedure
IP Trunk Description, Installation, and Operation
Page 503 of 644