Before You Begin - Nortel 1000 Description, Installation And Operation Manual
Networks communication server, ip trunk installation
Hide thumbs
Also See for 1000:
- Features and services fundamentals (616 pages) ,
- Fundamentals (492 pages) ,
- Installation and commissioning manual (468 pages)
Table of Contents
Advertisement
Page 240 of 644
Before you begin
553-3001-363
Standard 2.00
Install and configure IP Trunk 3.01 (and later) node
Follow the steps in Procedure 6 to ensure that installation requirements are
met.
Procedure 6
Meeting installation requirements
1
Install OTM 2.1 (and later). Make sure the ITG ISDN IP Trunk and Alarm
Management applications are installed.
2
Upgrade the system software to CS 1000 Release 4.0. IP Trunk 3.01 (and
later) requires packages 145 (ISDN) and 147 (ISL). Install additional
software packages, such as Package 148 NTWK, as required for
advanced ISDN features.
3
Verify that required LAN and WAN networking equipment and cables are
installed. For networking equipment requirements, refer to "ITG
engineering guidelines" on
cables.
4
The Media Card 32-port trunk card or ITG-Pentium 24-port trunk card,
DCHIP PC Card (NTWE07), and cable assemblies required for the site
are available.
5
For Large Systems, have the ITG ISL (NT6D80). For Small Systems, IP
Trunk 3.01 (and later) requires at least one available port on an SDI/DCH
card (minimum vintage NTAK02BB). Ensure D-channel cards have
required cables.
6
Verify that the customer site has a Nortel Networks Netgear RM356
Modem Router (or equivalent) on the ELAN subnet. The modem router
provides remote support access to IP Trunk 3.01 (and later) and other
IP-enabled Nortel Networks products on the Meridian 1 site. See
Appendix F on
September 2004
page
119. The IP trunk card requires shielded
page 607
for more information on routers.
End of Procedure
Advertisement
Table of Contents
