Transmit New Software To The Ip Trunk Cards - Nortel 1000 Description, Installation And Operation Manual

Page 360 of 644

Transmit new software to the IP trunk cards

553-3001-363 Standard 2.00
Install and configure IP Trunk 3.01 (and later) node
7 Download software packages and associated release notes as follows:
a. For Media Card 32-port trunk cards, download the Software
Package for Release IP Trunk 3.01 (and later).
b. For ITG-Pentium 24-port trunk cards, download the Software
Package for Release IP Trunk 3.01 (and later).
8 When prompted, select Download. Record the file name and location of
downloaded software on the OTM 2.1 (and later) PC.
Now the new IP trunk card software is ready to be transmitted from OTM 2.1
(and later) to the IP trunk cards.
Verify that the IP trunk cards are disabled before transmitting new card
software.
Note: Disable the IP trunk cards when transmitting card properties or
new software.
Use the OTM Maintenance Windows, the OTM System Passthru terminal, or
a system management terminal directly connected to a TTY port on the
system.
Use the LD 32 DISI command to disable the IP trunk cards when idle.
NPROG indicates that all units on the card have been disabled.
In the OTM IP Telephony Gateway - ISDN IP Trunk window, select
> Refresh
and verify that the card status is showing "Disabled". If the card
status shows "unequipped", configure the card in LD 14.
Follow the steps in Procedure 37 on
the IP trunk cards.
September 2004
End of Procedure
page 361 to transmit the new software to
View