Otm 2.1 (And Later) Maintenance Commands; Multi-Purpose Serial Data Link (Msdl) Commands; Simple Network Management Protocol (Snmp) - Nortel 1000 Description, Installation And Operation Manual

Page 526 of 644

OTM 2.1 (and later) maintenance commands

Multi-purpose Serial Data Link (MSDL) commands

Table 57
MSDL commands
Command
ENL DCH num
DIS DCH num
STAT DCH num
RLS DCH num
EST DCH num

Simple Network Management Protocol (SNMP)

553-3001-363 Standard 2.00
Maintenance
When changing DSP parameters in OTM 2.1 (and later), disable the IP trunk
card's ports before downloading the new parameters. Modifications to node
parameters require the affected cards to be rebooted. A dialing plan can be
modified without rebooting or disabling the cards.
All system MSDL commands are supported. Use LD 96 to enter MSDL
commands. Table 57 lists some of the more important commands.
Description
Enables the D-channel.
Disables the D-channel.
Displays the state of the D-channel application.
Releases the D-channel.
Establishes multiple frame operation on the D-channel.
An SNMP stack sends appropriate traps to OTM 2.1 (and later) or an SNMP
manager. A buffer containing received traps is also available through the CLI
if no SNMP/Alarm Manager exists.
September 2004