Configure Dsp Profiles For The Ip Trunk 3.01 (And Later) Node - Nortel 1000 Description, Installation And Operation Manual

Page 324 of 644

Configure DSP profiles for the IP Trunk 3.01 (and later) node

553-3001-363 Standard 2.00
Install and configure IP Trunk 3.01 (and later) node
Follow the steps in Procedure 20 to select a DSP profile, set Profile Options
and Codec Options and, if required, modify default DiffServ/TOS values
from 0. Set these profiles once for the IP Trunk 3.01 (and later) node. In a later
step, download the DSP profiles card properties to each card.
Procedure 20
Configuring DSP profiles for the IP Trunk 3.01 (and later) node
1 Click the DSP Profile tab. See Figure 53 on
displays a detailed description of the default DSP Profile 1.
2 Change the default DSP profile from the drop-down list, if required. There
are three DSP profiles. Each profile contains two or more codecs. All IP
trunk cards in the same node share the same DSP profile.
CAUTION
The default DSP profile is Profile 1, which is appropriate
for most applications. Only an expert in VoIP should
modify the default DSP profile. See "IP Trunk 3.01 (and
later) DSP profile settings" on
September 2004
page 325. The General tab
page 218.