Change Default Esn5 Prefix For Non-Esn5 Ip Telephony Gateways - Nortel 1000 Description, Installation And Operation Manual

Change default ESN5 prefix for non-ESN5 IP telephony
gateways
Figure 62
esn5PrefixShow
Install and configure IP Trunk 3.01 (and later) node
Follow the steps in Procedure 35 to configure an ESN5 prefix for the
non-ESN5 IP telephony gateways by using the "esn5PrefixSet" command
from the ITG shell CLI. The default esn5 prefix (100) corresponds to
NCOS 00. If NCOS 00 does not allow access to all the required trunk
facilities, change the default ESN5 prefix to work with the established NCOS
plan in the customer's network. Refer to "ESN5 network signaling" on
page 306. Perform this procedure on every card in the node.
Procedure 35
Changing the default ESN5 prefix for non-ESN5 IP telephony gateways
1 Select the new IP Trunk 3.01 (and later) node in the upper part of the
IP Telephony Gateway - ISDN IP Trunk window.
2 For each IP trunk card in the node, right-click the IP trunk card and select
Telnet to ITG Card from the right-click menu.
The Telnet window appears with the VxWorks prompt.
3 When prompted to login, enter the default (or user-modified) login and
password.
VxWorks login: itgadmin
Password: itgadmin
ITG> esn5PrefixShow
See Figure 62.
IP Trunk Description, Installation, and Operation
Page 357 of 644
default 100