Nortel 1000 Description, Installation And Operation Manual page 343

Install and configure IP Trunk 3.01 (and later) node
9 Check only the Dialing Plan check box if the community name for both
the existing and new nodes is the same.
Check the Dialing Plan check box and the Prompt user for community
name check box if the community name for both the existing and new
nodes are different. A dialog box appears. Enter the new node's
community name.
10 Click Start Retrieve and monitor progress in the Retrieve control field.
Ensure the dialing plan is retrieved successfully and added to the OTM
database.
11 Click Close to close the ITG Retrieve Options window and return to the
IP Telephony Gateway - ISDN IP Trunk window.
12 Select the new node and double-click to open its Node Properties sheet.
13 On the Configuration tab, change the Management IP address of
Leader 0 on the new node. Enter the correct Management IP address of
the Leader 0 card on the new node.
14 Click Change and then click OK.
15 Select menu Configuration > Node > Dialing Plan to open the ITG
Dialing Plan window.
16 Inspect the retrieved dialing plan for the new node and make any
necessary modifications. Double-click a dialing plan entry to inspect its
property sheet. To save modifications, click Apply and then OK.
From the View menu, the option is available to view by Digits dialed or
Remote Nodes.
End of Procedure
IP Trunk Description, Installation, and Operation
Page 343 of 644