Nortel 1000 Description, Installation And Operation Manual page 553

Follow the steps in Procedure 73 to transmit IP trunk card properties and the
dialing plan.
Procedure 73
Transmitting IP trunk card properties and dialing plan
1 In the IP Telephony Gateway window, select the replacement IP trunk
card.
2 Click menu Configuration > Synchronize > Transmit.
The ITG – Transmit Options window appears.
3 Select the Transmit to selected cards radio button. Check the Card
properties and Dialing plan boxes only.
Click the Start Transmit button.
The transmission status is displayed in the "Transmit control" box.
Confirm the card properties and dialing plan are transmitted correctly.
4 When the transmission is complete, click the Close button.
5 Use the LD 32 ENLC command to re-enable the IP trunk card.
6 In the IP Telephony Gateway main window, select menu View >
Refresh. The card status displays "Enabled."
7 Check the TN, management interface MAC address, and IP addresses for
each IP trunk card. Compare the displayed values with those on the IP
Trunk 3.01 (and later) Installation Summary Sheet.
8 Update the IP Trunk 3.01 (and later) Installation Summary Sheet with the
new MAC address of the replacement IP trunk card.
Maintenance
End of Procedure
IP Trunk Description, Installation, and Operation
Page 553 of 644