Otm 2.1 (And Later) Pc Hardware And Software Requirements - Nortel 1000 Description, Installation And Operation Manual

Page 234 of 644
OTM 2.1 (and later) PC hardware and software
requirements
553-3001-363 Standard 2.00
OTM 2.1 (and later) management and configuration of IP Trunk 3.01 (and later)
Each of the OTM 2.1 (and later) client PCs on the customer LAN is allowed
connectivity to the IP addresses of the Meridian 1s. Nortel Networks
recommends the following:
1 OTM 2.1 (and later) client PC in switchroom has access to the File Server
on the customer network.
2 Block broadcast messages from the customer LAN to the system private
LAN.
3 Block access to the system private LAN from non-OTM 2.1 (and later)
client PCs for security reasons.
The following list provides the recommended minimum PC hardware and
software recommended to run OTM 2.1 (and later). Other applications
launched while using OTM 2.1 (and later) can require increased RAM. The
minimum requirements are as follows:
• an Intel Pentium II Processor 400 MHz CPU minimum; Intel Pentium III
Processor 600 MHz CPU recommended
• 2 GB or larger hard disk drive with 1000 MB or more free space. Refer
to the system datastore column in the hard drive requirements in Table 37
on page 235.
• 256 MB of RAM (minimum); 512 MB recommended
• SVGA color monitor and interface card (800x600 resolution for
graphics)
• CD-ROM drive and 3.5 in 1.44 MB floppy disk drive
• two Ethernet Network Interface Cards
• Hayes-compatible modem is optional to connect to remote systems,
required for polling configurations (56 Kbps recommended)
• PC COM port with 16550 UART
• printer port (required for the dongle)
September 2004