Other Components; Media Card 32-Port Trunk Card Modem Connection - Nortel 1000 Description, Installation And Operation Manual

Install and configure IP Trunk 3.01 (and later) node
NTAK19BA four-port SDI/DCH cable
The NTAK 19BA cable is an Option 11C MDF cable for interfacing to the
4-port NTAK02 SDI/DCH card.

Other components

For Large Systems, I/O panel 50-pin filtered adapters NTCW84JA are
required for 100BaseT TLAN subnet operation.
IP Trunk 3.01 (and later) uses the ITG Card adapter ELAN/TLAN subnet to
route Ethernet signals through the Meridian 1 system I/O panel and through
system filtering. For standard 10BaseT operation, this inherent filtering in the
system does not pose a functional concern.
For 100BaseT Ethernet links, the Meridian 1/CS 1000M filtering does impact
functionality. Special consideration has been given to the routing of the
TLAN Tip and Ring pairs. On Meridian 1, some of the Tip and Ring pairs
have been left free of filtering. The TLAN subnet has been routed on the
Media Card 32-port trunk card to take advantage of this. By default,
100BaseT operation is fully functional on Small Systems.
Install ITG EMC shielding kit NTVQ83 with Small and Large System types.
Refer to "ELAN and TLAN interfaces" on
information on the cabling requirements.

Media Card 32-port trunk card modem connection

To provide remote access to the CLI for support and remote maintenance, a
modem can be connected to the serial port of the Media Card 32-port trunk
card. To set up a working interface, follow the steps in Procedure 16 on
page 286.
page 274
IP Trunk Description, Installation, and Operation
Page 285 of 644
for additional