Transmit Card Properties And Dialing Plan To Leader 1; And Follower Cards; Transmit Card Properties And Dialing Plan To Leader 1 And Follower Cards - Nortel 1000 Description, Installation And Operation Manual

Install and configure IP Trunk 3.01 (and later) node
2 Verify that the TN, management interface MAC addresses, and IP
addresses are configured correctly for each IP trunk card. Select any card
in the IP Trunk 3.01 (and later) node in the OTM ITG – ISDN IP Trunk
window and select menu Configuration > Node > Properties from the
drop-down lists. Compare the values displayed on the General tab and
the Card Configuration tab with those on the IP Trunk 3.01 (and later)
Installation Summary Sheet. The ITG – Transmit Options dialog box
appears.
3 Correct errors and retransmit Node Properties.
4 Reboot all cards for which Node Properties have changed.

Transmit card properties and dialing plan to Leader 1

and Follower cards

Verify that the IP trunk cards are disabled before transmitting card properties.
Note: Disable IP trunk cards when transmitting card properties or new
software.
Use the OTM 2.1 (and later) Maintenance Windows, the OTM 2.1 (and later)
System Passthru terminal, or use a system management terminal directly
connected to a TTY port on the system. Wait for the NPR0011 message,
which indicates that all units on each card are disabled.Use the LD 32 DISI
command to disable the IP trunk cards when idle. In the IP Telephony
Gateway - ISDN IP Trunk window, select View|Refresh and verify that the
card status is showing "Disabled". If the card status shows "unequipped",
configure the card in LD 14.
Follow the steps in Procedure 32 to transmit the card properties and dialing
plan to the Leader 1 and Follower IP trunk cards.
Procedure 32
Transmit card properties and dialing plan to Leader 1 and Follower
cards
1 Select the IP Trunk 3.01 (and later) node for which properties are to be
transmitted from the list in the upper part of the window.
2 Select Leader 0 from the list in the lower part of the window.
End of Procedure
IP Trunk Description, Installation, and Operation
Page 353 of 644