Nortel 1000 Description, Installation And Operation Manual page 356

Page 356 of 644
553-3001-363 Standard 2.00
Install and configure IP Trunk 3.01 (and later) node
3 When prompted to login, enter the default username and password as:
VxWorks login: itgadmin
Password: itgadmin
ITG>
4 Use the command shellPasswordSet to change the default user name
and password for Telnet to ITG shell and FTP to the IP trunk card file
system. The default user name is itgadmin and the default password is
itgadmin.
Enter the following information when prompted:
Enter current username: itgadmin
Enter current password: itgadmin
Enter new username: new username
Enter new password: new password
Enter new password again to confirm: new password
5 Record the new user name and password and transmit to authorized
network security personnel.
6 Repeat procedure for all cards in the node.
If the entire sequence of commands is successfully entered, the system
response value = 0 = 0x0 is displayed. The new user name and password
are now stored in the non-volatile RAM on the IP trunk card and are retained
even if the card is reset, powered-off, or on.
To reset the ITG shell password to its default setting, see "Reset the default
ITG shell password" on
September 2004
End of Procedure
page 491.