Nortel 1000 Description, Installation And Operation Manual page 594

Page 594 of 644
553-3001-363 Standard 2.00
Appendix B: Cable description and NT8D81BA cable replacement
c. Install connector 3, (labeled UP3^) into backplane shroud 3.
3 Dress ribbon cables back individually inside the rear of the IPE module
and restore the original arrangement. Start with the cables that are going
to be underneath.
4 Attach the NTCW84JA special IPE filter to the NT8D81AA 50-pin
connector using bail clips.
5 Restore power to the IPE module.
6 Replace I/O safety panel.
September 2004
End of Procedure