Configuration Audit; Retrieve Ip Trunk 3.01 (And Later) Configuration Information From The; From The Ip Trunk 3.0 (And Later) Node - Nortel 1000 Description, Installation And Operation Manual

OTM 2.1 (and later) OA&M using OTM 2.1 (and later) applications
To view the data of a real IP Trunk 3.01 (and later) node, select the "dummy"
node and change the management IP address in the node properties to access
the needed node. Use the menu
function to retrieve data from that node and overwrite the dummy node's data.

Configuration audit

In this procedure, retrieve the card properties and dialing plan from each IP
trunk card in the selected IP Trunk 3.01 (and later) nodes. OTM compares the
retrieved data with the card properties and dialing plan currently stored in the
OTM 2.1 (and later) database. OTM 2.1 (and later) provides a report that
shows cards where the data matches and cards where the data is different. To
view the differences, use the menu
temporary node. Then use the menu
retrieve the IP trunk card properties or dialing plan from the selected IP trunk
card. Double-click the temporary node to view the IP trunk card properties
and open the dialing plan for the temporary node to view the dialing plan
entries. Compare the data with the properties and dialing plan for the
currently stored IP Trunk 3.01 (and later) node in OTM 2.1 (and later).
Retrieve IP Trunk 3.01 (and later) configuration information

from the IP Trunk 3.0 (and later) node

Use the optional Procedure 59 on
• when adding an IP Trunk 3.01 (and later) node on OTM by retrieving an
existing node
• when it is known that the IP Trunk 3.01 (and later) node configuration on
the IP trunk card is different from the OTM IP Trunk 3.01 (and later)
database (for example, during maintenance and fault isolation
procedures)
• when there are multiple OTM PCs with multiple instances of the
database (administration)
Use the OTM ITG menu
to retrieve the IP Trunk 3.01 (and later) configuration information from the
IP Trunk 3.01 (and later) node.
Configuration > Synchronize > Retrieve
Configure > Node > Add
Configure > Synchronize > Retrieve
page 474 in the following situations:
Configuration > Synchronize > Retrieve
IP Trunk Description, Installation, and Operation
Page 473 of 644
to add a
to
command