Nortel 1000 Description, Installation And Operation Manual page 611

Appendix F: Configure a Netgear RM356 modem router for remote access
2
3
4
5
6
7
8
9
10 Under "TCP/IP Setup", type in the IP address and the IP subnet mask for
11 Toggle "RIP Direction=None". Press Enter to confirm and save data to
12 Enter menu selection number 12, "Static Routing Setup", under the
Enter the default RM356 manager password: 1234
The "RM356 Main Menu" appears.
Enter menu selection number 1 to access "General Setup" under the
"Getting Started" section of the "RM356 Main Menu."
"Menu 1 – General Setup" is displayed.
Type in the system name (19 characters, no spaces), location, and
contact person's name for the system site. Use the up and down arrow
keys to move the cursor to the prompt "Press ENTER to Confirm or ESC
to Cancel:" at the bottom of the menu. Press Enter to confirm and save
data to ROM.
Enter menu selection number 2 under the "Getting Started" section.
"Menu 2 – Modem" is displayed.
Type in modem name. Set "Actives". Use arrow keys to navigate and
space bar to toggle values. Set "Direction=Incoming". Type in the modem
router's telephone number for reference. Press Enter to confirm and save
data to ROM.
Enter menu selection number 3, "Ethernet Setup", under the "Getting
started" section.
"Menu 3 – Ethernet Setup" sub-menu is displayed.
Enter menu selection 2, "TCP/IP and DHCP Setup".
"Menu 3.2 – TCP/IP and DHCP Ethernet Setup" is displayed.
Use the space bar to toggle "DHCP=None".
the modem router's ELAN Ethernet interface.
ROM, then press Esc to return from the sub-menu to the main menu.
"Advanced Applications" section.
"Menu 12 – Static Route Setup" sub-menu is displayed.
IP Trunk Description, Installation, and Operation
Page 611 of 644