Ip Trunk 3.01 (And Later) Configuration Commands; Download The Ip Trunk 3.01 (And Later) Error Log; System Commands - Ld 32 - Nortel 1000 Description, Installation And Operation Manual

IP Trunk 3.01 (and later) configuration commands

Table 52

IP Trunk 3.01 (and later) configuration commands

Command
setLeader
clearLeader
NVRIPShow

Download the IP Trunk 3.01 (and later) error log

System commands – LD 32
OA&M using the ITG shell CLI and overlays
Table 52 lists the IP Trunk 3.01 (and later) configuration commands.
Description
The one command that performs all the necessary actions to
make a Leader. Sets the IP address, gateway, subnet mask,
boot method to static, and leader bit in NVRAM.
Enter this command to clear the Leader information in NVRAM
and set the boot method to use BOOTP, making the card a
Follower.
Enter this command to print the values of the IP parameters
that exist in NVRAM.
The IP Trunk 3.01 (and later) error log contains error conditions and normal
events. Some of the error conditions can be severe enough to raise an alarm
through SNMP traps.
The following commands can download an IP Trunk 3.01 (and later) error
log:
• currLogFilePut
• prevLogFilePut
Perform the following system administration commands using LD 32:
• "Disable the indicated IP trunk card" on page
IP Trunk Description, Installation, and Operation
Page 507 of 644
510.