Add The Node - Nortel 1000 Description, Installation And Operation Manual

Page 410 of 644

Add the node

553-3001-363 Standard 2.00
Provisioning IP Trunk 3.01 (and later) in OTM 2.1 (and later)
18 This tab is only present for IP Trunk 3.01 (and later) nodes. Use the
drop-down list to select the RTP port starting value. There are two
options, as follows:
• 2300 – default value
• 17300 – used for Cisco RTP header compression
Alternatively, enter any even-numbered port starting value between 1024
and 65534.
WARNING
Entering a starting port value other than 2300 or 17300
does not block calls, but can result in unexpected
behavior, as certain port ranges are reserved by the
IETF.
Cisco header compression can be used only if a starting
port value is entered that is equal to or greater than
17300.
Click the Restore Default button to restore the default port start value.
19 Click OK to complete the node provisioning. The ITG Node Properties
window closes. The node data is now displayed in the ITG – ISDN IP
Trunk window. See Figure 101 on
September 2004
page 411.