Iot Motor, Solenoid Testing Procedures - Xerox Phaser 6128MFP Service Manual

IOT Motor, Solenoid Testing Procedures

Phaser 6128MFP Service Manual
Procedures for testing each IOT motors, solenoids and erase lamps using Service
Diagnostics.
Sub Motor
Main Motor
K Mode Solenoid
Registration Clutch
Main Motor
The Main Motor drives the transfer belt and Imaging Unit drums.
Note
Install the interlock override to provide power to the device under test.
1. Enter Service Diagnostics (page 4-4).
2. Open the Front Cover.
3. Perform the Main Motor test: Engine Diag > Motor Test > Main Motor DO-0,
DO-1, DO-2. The rotational speed order of the Main Motor test is DO-2 > DO-0
> DO-1.
4. Verify that the Main Motor is running, the imaging unit drums are rotating,
and the transfer belt is moving.
Fan (High / Low)
Tray 2 Feed Solenoid (Half / Full Rotation)
Tray 2 Feed Solenoid (Auto Off)
General Troubleshooting
Black Toner Motor
Cyan Toner Motor
Magenta Toner Motor
Yellow Toner Motor
Black Drum Erase Lamp
Yellow, Magenta And
Cyan Drum Erase Lamp
s6128mfp-081
4-41