Jam At Manual Feed Slot - Xerox Phaser 6128MFP Service Manual

Jam at Manual Feed Slot

Phaser 6128MFP Service Manual
The Registration Sensor is not turned On within the specified time. The following
troubleshooting procedure applies to these errors.
Applicable Error
• Jam at Manual Feeed Slot
Initial Actions
• Check the media path for obstructions or debris.
• Check the media size being used.
• Cycle printer power.
• If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Registration Clutch, PL3.1.1
Registration Roller Actuator, PL3.3.8
Registration Sensor, PL3.2.13
Main Drive Assembly, PL7.1.2
Feed Drive Assembly, PL7.1.4
Left Side Harness, PL10.4.18
MCU Board, PL10.7.7
Main Motor Harness, PL10.8.7
Registration (KSNR) Harness, PL10.8.9
Troubleshooting Procedure Table
Step Actions and Questions
1 Check the media size.
Does the media maatch the print
job size?
2 Check the Front Cover latch.
Does the Front Cover latch correctly?
3 Run the Main Motor test (DO-00) on
(page 4-41).
Does the motor rotate?
4 Does the media reach the
Registration Rollers when fed from
the Tray?
Error Messages and Codes
Wiring and Plug/Jack Map References
"Map 2 - Feed and Laser Unit" on page 10-7
"Map 4 - Imaging" on page 10-9
"Media Feed" on page 10-15
"Main Drive" on page 10-16
Yes
Replace the
media.
Go to step 3.
Go to step 4.
Go to step 5.
No
Go to step 2.
Repair or
replace the
Front Cover
(page 8-15).
Go to step 15.
Go to step 7.
3-47