Reseat Fuser Error - Xerox Phaser 6128MFP Service Manual

Error Messages and Codes

Reseat Fuser Error

Applicable Error
Initial Actions
3-56
Troubleshooting Procedure (continued)
Step Actions and Questions
4 Replace the Fuser (page 8-11).
Does the error persist?
NOTE
Reset the Fuser life counter after
installation of a new Fuser.
5 Replace the LVPS (page 8-47).
Does the error persist?
Warning
Allow the Fuser to cool before removal.
The Fuser has failed. This troubleshooting procedure applies to this error.
• 010-317: ReseatFuser
• Ensure that the Fuser latches are fully locked.
• Cycle printer power.
• If problem persists, follow the procedure below.
Troubleshooting References
Applicable Parts
Fuser, PL6.1.1
MCU Board, PL10.7.7
Fuser Harness, PL10.8.6
Troubleshooting Procedure
Step Actions and Questions
1 Check the connectors P/J17 and P/J171
between the MCU Board and the Fuser.
Are the connectors secure?
Yes
Go to step 5. Complete.
Replace the
MCU Board
(page 8-57).
Wiring and Plug/Jack Map References
"Map 4 - Imaging" on page 10-9
"Fuser" on page 10-21
Yes
Go to step 2. Reconnect
Phaser 6128MFP Service Manual
No
Complete.
No
the
connectors.